2.19 Fusion Power Designer: Import and export project files

Previous Next

Description

August 9, 2018

The Fusion Digital Power Designer allows users to configure and monitor TI's familes of TPS404x, TPS5x, and UCD90x sequencers. This video shows how to import and export project files in the GUI.

Additional information

Fusion Digital Power Designer

1Getting started (3)

This section explains how to connect the EVMs and download, install, and launch the Fusion Digital Power™ Designer.

02:28

1.1 UCD90x: Getting started with the Fusion Power Designer

00:45

1.2 Fusion Power Designer: Download the GUI

00:45

2.19 Fusion Power Designer: Import and export project files

Description

Additional information

1Getting started (3)

1.1 UCD90x: Getting started with the Fusion Power Designer

1.2 Fusion Power Designer: Download the GUI

1.3 Fusion Power Designer: Installing the GUI

2Using the Fusion Digital Power™ Designer (28)

2.1 Fusion Power Designer: Configure a voltage rail

2.2 Fusion Power Designer: Configure set points for a voltage rail

2.3 Fusion Power Designer: Add and configure a GPI input

2.4 Fusion Power Designer: Add additional voltage rails

2.5 Fusion Power Designer: Set rail sequencing

2.6 Fusion Power Designer: Set fault response

2.7 Fusion Power Designer: Set up a margining function

2.8 Fusion Power Designer: Add a logic-controlled GPO

2.9 Fusion Power Designer: Configure a rail to monitor current

2.10 Fusion Power Designer: Configure a rail to monitor temperature

2.11 Fusion Power Designer: Enable or disable a fault log

2.12 Fusion Power Designer: Setup a system reset function

2.13 Fusion Power Designer: Set up the system watchdog function

2.14 Fusion Power Designer: Pin Selected Rail States

2.15 Fusion Power Designer: Set up security mode

2.16 Fusion Power Designer: Error checking function

2.17 Fusion Power Designer: Import and export system files

2.18 Fusion Power Designer: How to import and export data flash script files

2.19 Fusion Power Designer: Import and export project files

2.20 Fusion Power Designer: Import and export data flash hex files

2.21 Fusion Power Designer: Compare different project files

2.22 Fusion Power Designer: Rail monitor function

2.23 Fusion Power Designer: Status function

2.24 Fusion Power Designer: System monitor function

2.25 Fusion Power Designer: Using the UCD90xxx Device GUI

2.26 Fusion Power Designer: Low level I2C SMBus debugger

2.27 Fusion Power Designer: Change dongle settings

2.28 Fusion Power Designer: How to upgrade dongle firmware

2.19 Fusion Power Designer: Import and export project files

Description

Additional information

1Getting started (3)

2Using the Fusion Digital Power™ Designer (28)

Related courses and events