The EADC sample trigger comes from a DPWM module. This tutorial explains how to route a sample trigger from DPWM0 to Front End 0 via the loop mux. 

The front end module's reference DAC is used as the reference against which the power supply sensed feedback signal is compared. This tutorial explains how to s

Other AFE features are touched upon in this video, such as averaging the EADC output, using the front end module as a lower bandwidth and higher accuracy Succes

This video shows how to setup the UCD3138 open loop board for the closed loop demonstration. This closed loop demo uses all three Digital Power Peripherals and

We show how to setup the UCD3138 open loop board for the closed loop demonstration. For the closed loop demo, we use all three Digital Power Peripherals and som

This video explains the firmware required to create the closed loop and shows key signals on the open loop board on an oscilloscope. 

This video introduces the hardware and software required to communicate with the UCD3138 series of digital power controllers via JTAG. Modifications that may ne

This video demonstrates how to download and install Code Composer Studio (CCS) with JTAG support. 

A once off modification that needs to be made to a file on your computer to enable JTAG comms with the UCD3138 series via the xds510USB hardware emulator is sho

This video will show how to establish a JTAG communications link between Code Composer Studio (CCS) and a UCD3138x device.  

This video presents the programming options supported by the CCS JTAG flash programming GUI. Since the CCS JTAG flash GUI was designed to be as similar as possi

This tutorial will show how to use the CCS JTAG debugger. Specifically, it includes how to: - run and halt the program - single step the program - view the rele

This video demonstrates how to export the contents of flash to a file after programming. Please note that this can be a time consuming operation, so it is recom

On the UCD3138, JTAG comms are disabled by default by the ROM code that executes on device startup. This video outlines the steps required to enable comms on th

On startup, checksums tests are executed by the boot ROM code to verify the integrity of the program flash contents. If any of these tests pass, JTAG comms are

This video shows how to download Uniflash, and how to use Uniflash.

Learn how the Uniflash GUI interface could be used in a production setting

Learn about the command line in Uniflash

The presentation then compares programming times for a couple of different programming scenarios.